Health · Body composition

Body fat percentage calculator

Enter a few tape-measure circumferences to estimate your body fat percentage using the U.S. Navy method.

Your measurements

Measure waist at the navel and neck just below the larynx. Women also measure hips at the widest point.

Estimated body fat
—
—
Lean mass %—
MethodU.S. Navy

Rough sheet

step-by-step

How to get an accurate body fat reading

The Navy method is only as good as the tape-measure readings you feed it, and small measuring errors are amplified by the logarithms in the formula. Measure first thing in the morning, before eating or exercising, and relax rather than sucking in your stomach. Keep the tape snug but not compressing the skin, parallel to the floor, and take each measurement twice, using the average if the two differ.

The formulas, with a worked example

All measurements are in inches. For men: body fat % = 86.010 × log10(waist − neck) − 70.041 × log10(height) + 36.76. For women: body fat % = 163.205 × log10(waist + hip − neck) − 97.684 × log10(height) − 78.387.

Example: a man who is 70 inches tall with a 34-inch waist and 15-inch neck has a waist-minus-neck value of 19. log10(19) is about 1.279 and log10(70) is about 1.845, so the result is 86.010 × 1.279 − 70.041 × 1.845 + 36.76 ≈ 17.5% body fat.

Typical body fat ranges

The American Council on Exercise publishes widely used reference ranges. Healthy ranges for women are higher than for men because of essential sex-specific fat.

CategoryWomenMen
Essential fat10–13%2–5%
Athletes14–20%6–13%
Fitness21–24%14–17%
Average25–31%18–24%
Above average32% and over25% and over

Limits of the estimate

Circumference methods assume an average fat distribution. Someone who carries unusually muscular shoulders and neck, or stores fat mainly in the hips or thighs, can get a reading that is off by several percentage points. DEXA scans, hydrostatic weighing and the Bod Pod are more accurate but require a clinic or lab. For tracking your own progress, use the same method, the same time of day and the same tape each time; the trend across weeks matters far more than any single number.

Frequently asked questions

It's a circumference-based estimate, typically within about 3-4% of more precise methods like DEXA scans. It's a convenient way to track trends over time rather than a lab-exact measurement.

Yes, toggle between metric (cm) and imperial (in) at the top of the calculator.